Spider Fittings
Product code — to be assigned
Cast stainless spiders and glass connectors that pick up point-fixed glass panels at a single node.
- 2, 3 and 4-arm configurations
- Cast 304 / 316 stainless
- Adjustable arms to the point layout
- Arm count
- 2 / 3 / 4 (confirm per layout)
- Material
- Cast stainless steel 304 / 316
- Finish
- Mirror or satin
- Glass build-up
- 8 – 15 mm monolithic, or laminated / IGU
Quoting from Handan, Hebei Province, China. Reply capacity depends on the completeness of the specification supplied with the enquiry.
Product information
A point-fixed facade holds each glass panel at four corner holes rather than in a frame. The spider is the casting at the node that receives those four corners on adjustable arms, so the whole glass surface reads as one plane with the joints doing the work.
Arm count, arm length and the glass connector type come from the point layout. Castings are supplied in 304 or 316 stainless, mirror or satin finished, with the connector matched to the glass build-up and the hole pattern the structural engineer has set.
Typical applications
- Point-fixed glass facades
- Canopies and entrance glazing
- Glass fin and cable-net systems
Packing & delivery
- Individually wrapped, one spider per box
- Connectors and gaskets in the same carton
- Palletized for export
Customization (confirmed per order)
- Arm length and count to the layout
- 316 for coastal and pool environments
- Connector matched to glass build-up
Material & finish
- Material
- Cast stainless steel 304 · Cast stainless steel 316
- Finish
- Mirror polished · Satin
- Standard reference
- Geometry follows the point layout and the glass hole pattern. Structural capacity depends on the glass, the hole position and the supporting structure, and is confirmed by the facade engineer.
Frequently asked questions
Does the glass need drilled holes?
Yes. Point fixing requires a hole at each corner, positioned to the engineer's edge distance. The hole pattern has to be agreed before the glass is tempered — it cannot be drilled afterwards.
How is the arm count chosen?
By where the panel sits. Interior nodes of a grid take four arms, edges take two or three, and corners take one. The point layout drawing shows which applies.
Are current photographs available?
Yes — request them with your enquiry. The images on this page are placeholders until the workshop photos are supplied.
Request a quotation
The product name is already attached to this form. Add the dimensions, quantity, material and finish required, and attach a drawing if one exists.
- tangtiemetal@163.com
- Phone / WhatsApp
- +86 16619861146
- Location
- Handan, Hebei Province, China
